Kia Telluride: Installing a child restraint system (CRS) / Securing a child restraint seat with “Tether Anchor” system
|
|
|
Before attaching the tether strap, first secure the Child Restraint System (CRS) using either the LATCH lower anchors or the vehicle seat belt. If the CRS manufacturer recommends using a top tether, connect it to the appropriate tether anchor and tighten it according to the manufacturer's instructions. Proper tether use helps improve the overall stability of the child seat in your Kia Telluride.
The tether anchor points are located on the rear seatbacks.
WARNING
Observe the following precautions whenever using a tether anchor:
-
Carefully read and follow every installation instruction supplied with your Child Restraint System.
-
Never attach more than one Child Restraint System to a single tether anchor. Excessive load may cause the anchor or attachment hardware to loosen or fail.
-
Attach the tether strap only to the designated tether anchor. Connecting it to any other part of the vehicle may prevent the system from functioning correctly during a collision.
-
Do not use tether anchors to secure adult seat belts, cargo, harnesses, or any accessories other than an approved Child Restraint System.
-
Whenever the rear seat belts are not being used to secure a CRS, buckle them behind the child seat. This helps reduce the risk of a child becoming entangled in the seat belt.
To install and secure the tether strap:
|
-
Route the tether strap over the seatback.
On vehicles equipped with adjustable headrests, guide the tether strap beneath the headrest and between the headrest posts. If the headrest is not adjustable, route the strap over the top of the seatback.
- Attach the tether hook to the designated tether anchor and tighten the strap according to the Child Restraint System manufacturer's instructions until the CRS is firmly secured.
- After installation, confirm that the Child Restraint System is securely attached by pushing and pulling it forward and side to side. Only minimal movement should be present.
Securing a child restraint system (CRS) with the LATCH anchors system
To install a LATCH-compatible Child Restraint System in either rear outboard seating position of your Kia Telluride: Move the seat belt buckle away from the lower anchors to prevent accidental contact...
Securing a CRS with a lap/shoulder belt
If the LATCH system is not being used, the Child Restraint System must be installed using the lap portion of the vehicle's lap/shoulder seat belt in accordance with both the CRS manufacturer's instructions and the Kia Telluride owner's manual...
Other information:
Kia Telluride (LQ2, 2027-2026) Owner's Manual: If you have a flat tire (with spare tire)
If you experience a flat tire while driving your Kia Telluride, you can safely utilize the factory emergency tools and underbody hoist mechanism to replace the damaged wheel with the temporary spare tire. WARNING Driving on a flat or severely under-inflated tire inflicts irreversible internal structural damage to the casing.
Kia Telluride (LQ2, 2027-2026) Owner's Manual: With the mechanical key
The mechanical key can be used to manually lock or unlock the driver's door whenever the smart key battery is discharged or the electronic locking system is unavailable.